Is there a way to set the Tab Stop Value for a project? I have only found the one overall/general tab stop setting in the Advanced Configuration dialog.
I work with some guys who prefer 4 char tab stops and others who prefer 3 chars. It would be nice if the tab stop setting could be made on a project basis and would change automatically as you load each project.
IDM Computer Solutions, Inc. Forums
UltraEdit, UEStudio, UltraCompare, and UltraSentry
Welcome to the IDM Forum. This forum is meant as a user-to-user support mechanism where users can share knowledge and tips for all IDM software.
Since these forums are user-to-user based, IDM does not regularly read or reply to the posts in this forum. For problem reports, suggestions, or feature requests, you must email us directly. Our trained technical support staff answers most inquiries within 30 minutes.
Project tab stop setting
2 posts
• Page 1 of 1
Project tab stop setting
by kkramb » Mon Jun 12, 2006 7:01 pm
-
kkramb - Newbie
- Posts: 2
- Joined: Sun Jun 04, 2006 11:00 pm
Re: Project tab stop setting
by Mofi » Tue Jun 13, 2006 5:34 am
No, this is not possible. Tab stop settings can be only specified on a file extension basis but not project specific. This is one reason why I use also special INI files for some projects. There are other settings which are in my usage also project specific but cannot be saved in the project file.
-
Mofi - Grand Master
- Posts: 3936
- Joined: Thu Jul 29, 2004 11:00 pm
- Location: Vienna
2 posts
• Page 1 of 1